Today, I'm on a roll… </p> <p> For the past few weeks, I've been spending a lot of time looking into methods for extracting the 1/n octave analysis of a measured signal as best as possible. When I was deep into my research, there were a few methods...
I'm sure there are a good handful of you out there wondering what I'm planning to add to future releases of FuzzMeasure. To tell you the truth, I'm not quite sure what will actually make it into my 1.2 release, because there are so many ideas rushing...
I just finished off the last of the emails notifying my customers and “the press” about FuzzMeasure 1.1. It feels good to finally get this release out the door, as I was technically done for a little while. There was just a hiccup with getting a...
Just when I was about to give up on receiving my replacement device from M-Audio, it shows up. I was totally ready to drop the idea of keeping this thing, and buying something else (and eBaying the new device once it arrived). Fortunately, I didn...
Since the FuzzMeasure 1.1 release is essentially on hold until I get my hands on an audio device, I've decided to start looking further into my loudspeaker box simulation software. One thing's for certain – it's a lot to wrap your head around. </p...
Looking back on 2004, I must say that I did a pretty good job of adhering to my New Year's Resolution. For 2004, I resolved to finish the projects that I start, or ditch them completely if they were not worth finishing. I wasn't going to allow myself...
Yesterday, the wife and I decided to grab an iSight with some of our gift money. Our primary reason was that we wanted to have the ability to videoconference with my in-laws who are now located in the US. We've mucked around with it last night, and...
I will probably be out of commission for a few days before getting some more serious FuzzMeasure work done during my holiday break. You know, with all that eating and drinking, there's a little bit of recovery required… :) </p> <p> Unfortunately...